Creating A New Point - Leica GPS1200+ Technical Reference Manual

9.3.2
Access
Create point step-by-
step
Manage...\Data

Creating a New Point

Refer to "9.2 Accessing Data Management" to access MANAGE Data: Job Name.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. MANAGE Data: Job Name, Points page
2. NEW (F2) to access MANAGE New Point.
3. MANAGE New Point, Coords page
<Point ID:> The name of the new point. The configured point ID
template is used. The ID can be changed in the following ways:
• To start a new sequence of point ID's type over the point ID.
• For an individual name independent of the ID template SHIFT
INDIV (F5). SHIFT RUN (F5) changes back to the next ID from
the configured ID template.
Enter a point ID and the coordinates.
COORD (F2) views other coordinate properties.
Negative geodetic coordinates are interpreted as being of the oppo-
site hemisphere or other side of the central meridian. For example,
entering -25 °N will be stored as 25 °S, entering -33 °E will be stored
as 33 °W.
GPS1200+
Refer to
chapter
170