Table of Contents
Advertisement
Field procedure step-
by-step
Config...\Survey Settings...
Step
Description
4.
CONT (F1) returns to CONFIGURE ID Templates.
5.
CONFIGURE ID Templates
<Survey Pts: Bolt 001>
6.
CONT (F1) returns to the screen from where CONFIGURE ID Templates was
accessed.
Step
Description
1.
Refer to "45.3 Surveying Points" to access SURVEY Survey: Job Name.
2.
SURVEY Survey: Job Name
<Point ID: Bolt 001> is shown automatically.
At the point to be measured, place and level the pole on the point.
3.
OCUPY (F1)
4.
STOP (F1)
5.
STORE (F1)
<Point ID: Bolt 002> is shown automatically.
6.
Repeat steps 2. to 4. until all points with the ID Bolt XXX are surveyed.
7.
SURVEY Survey: Job Name
The next point ID's are RoadXXXX, starting with Road0723.
Type Road0723. <Point ID: Road0723>.
8.
OCUPY (F1)
GPS1200+
385
Advertisement
Table of Contents
