1.3
Use
Description
Equipment Setup
Post-Processed Static Reference on Tripod
The equipment setup described below is to be used for static operations over markers.
The receiver and the RX1200 if used can be assembled to make one unit. The receiver is
either clipped to the tripod leg or is placed in the transport container. One connection is
needed to connect the GNSS antenna to the receiver. Note that the receiver can be
programmed with the RX1200 prior to use which can then be omitted from the setup.
•
GNSS antenna is mounted directly using screw fitting. If using stub and adapter, proce-
dures may vary slightly.
•
GNSS antennas are AX1201 or AX1203+ GNSS. Procedures/setup may vary if
AR25/AT504 GG is used.
GPS1200+
35