Table of Contents
Advertisement
Equipment setup step-
by-step
Equipment Setup
a) SmartAntenna
b) Battery for SmartAntenna
c) Upper half aluminium pole with screw or stub k) 1.2 m antenna cable
d) Clip for cable
e) Grip for pole
f) GHT56
g) Radio in housing
h) Lower half aluminium pole
Step
Description
1.
Refer to "1.10 SmartRover - External Radio". Follow steps 1. to 4.
2.
Clip the antenna arm to the SmartAntenna.
3.
Screw the radio antenna onto the antenna arm.
4.
Insert the CompactFlash card into the RX1250X.
5.
Insert the battery into the RX1250X.
6.
Attach the RX1250X to the GHT56.
7.
Attach the radio in its housing to the GHT56.
8.
Place the battery into the battery compartment of the GHT56.
9.
Attach the GHT56 to the pole and tighten the screw.
10.
Connect the radio antenna to the radio housing using the 1.2 m antenna cable.
11.
Press PROG on the RX1250X to switch on.
RX1250X and SmartAntenna are connected via Bluetooth.
i) Radio antenna
j) Radio antenna arm 15 cm long
l) Battery for RX1250X
m) CompactFlash card
n) RX1250X
o) Battery for radio
GPS1200+
70
Advertisement
Table of Contents
