Leica GPS1200+ Technical Reference Manual page 607

Configure radio
channel step-by-step
Config...\Interfaces... - Controlling Devices
Channel changing may contravene radio broadcasting regulations in certain countries.
Before operating with radios, check the regulations in force in the working area.
The number of channels available and the frequency spacing between channels depends on
the radio used.
If channel changing is to be used, when configuring the reference real-time interface, set
<Ref Stn ID:> in CONFIGURE Additional Reference Options, General page to a different
ID for each reference site. By doing so, the rover can recognise if the incoming real-time data
after channel changing is being received from a different reference station or if the original
reference station is using a new frequency. In the first case, the ambiguities are recomputed.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. Refer to "22.2 Accessing Configuration Interfaces" to access
CONFIGURE Interfaces.
2. In CONFIGURE Interfaces highlight an interface which has a radio
attached.
3. CTRL (F4) to access CONFIGURE Radio Channel.
4. CONFIGURE Radio Channel
<Radio Type:> The type of radio highlighted when CONFIGURE
Radio Channel was accessed.
GPS1200+
Refer to
chapter
23
607