Selecting A Result From Previous Cogo Inverse Calculations - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Select a result from

previous COGO inverse

calculations step-by-

Selecting a Result from Previous COGO Inverse Calculations

Azimuths, distances and offsets required within the COGO traverse and intersection calcu-

lations can be selected from previously calculated inverse results.

Refer to "38.2 Accessing COGO" to access COGO Traverse Input or COGO

Intersection Input.

COGO XX Input, Input page

Highlight <Azimuth:>, <HDist-XX:> or <Offset:>.

LAST (F4) to access COGO Last Inverse Calculations.

COGO Last Inverse Calculations

All previous COGO inverse calculations stored in the active job are displayed,

sorted by time with the most recent at the top. This screen consists of three

First column From:

The point ID of the first known point for the COGO inverse calculation.

Second column To:

The point ID of the second known point for the COGO inverse calculation.

Third column:

The information displayed can vary. ----- is displayed for unavailable informa-

tion, for example if a height only point is used, Azimuth cannot be calculated.

Azimuth: The direction from the first to the second known point.