Table of Contents
Advertisement
COGO
Step
Description
<TPS Measmnt:> The point ID of the TPS measurement which is the
known end point of the first line for the COGO calculation.
<Azimuth:> The azimuth related to the known end point of the first
line for the COGO calculation.
<2nd TPS Stn:> The point ID of the second TPS station which is the
known start point of the second line for the COGO calculation.
<TPS Measmnt:> The point ID of the TPS measurement which is the
known end point of the second line for the COGO calculation.
<Azimuth:> The azimuth related to the known end point of the
second line for the COGO calculation.
Points can only be selected from the active job.
The value for the azimuth can be calculated from two existing points. 38.4
INV (F2) when <Azimuth:> is highlighted. To perform a COGO
inverse calculation.
Upon pressing STORE (F1) in COGO Inverse, the result from
the COGO inverse calculation is copied to the field which was
highlighted when INV (F2) was pressed.
For <Write Logfile: Yes> in COGO Configuration, Logfile
page the result of the COGO inverse calculation is written to
the logfile.
The value for the azimuth can be selected from previous COGO
inverse calculations.
GPS1200+
Refer to
chapter
38.12
856
Advertisement
Table of Contents
