Using Gps1200+ Without Rx1200 - Leica GPS1200+ Technical Reference Manual

3
Use
Description
Use GPS1200+ without
RX1200

Using GPS1200+ without RX1200

Using GPS1200+ without RX1200
For reference stations in post-processing, real-time and static applications, GPS1200+ can
be used without RX1200.
The receiver is pre-programmed in the office using the RX1200. In the field, the receiver is
used without the RX1200 attached. This greatly reduces the knowledge required to operate
the instrument in the field. Usually, a tripod or pillar setup is used.
Refer to "14 Manage...\Configuration Sets" for full instructions on how to program the
receiver.
Step Description
1. Set up the equipment according to the needs. Refer to "1 Equipment Setup" for
details of the equipment setup.
2. Hold down the ON/OFF button on the receiver for at least 2 s to switch the receiver
on.
3. Check the start time.
4. Note down information such as
• start time.
• antenna height.
• point ID.
This information is required for post-processing. Refer to paragraph "Field Record
Sheet" for an example for a field record sheet.
GPS1200+ 107