Table of Contents
Advertisement
Equipment setup step-
by-step
Equipment Setup
c) Grip for pole
d) RX1210
e) Holder for RX1210 on pole
f) Lower half aluminium pole
g) 1.2 m antenna cable
h) 1.6 m antenna cable
i) Radio in housing
Step
Description
1.
Refer to "1.4 Post-Processed Kinematic, Pole and Minipack". Follow steps 1. to 8.
2.
Attach the radio in its housing to port P1 or P3 on the receiver.
3.
Place the receiver in the minipack with the top side facing outwards and the
receiver front panel to the top.
4.
Fasten the strap around the receiver.
5.
Push the telescopic rod through the slit in the top of the minipack. Ensure it is
located in the sleeve inside the minipack and push it all the way to the bottom.
6.
Adjust the height of the telescopic rod to suit.
7.
Screw the radio antenna arm onto the telescopic rod.
8.
Connect the first 1.2 m antenna cable to the radio antenna.
9.
Pass the cable through the opening in the top of the minipack and down under-
neath the receiver.
10.
Connect the first 1.2 m antenna cable to the radio.
11.
Connect the 1.6 m antenna cable to port ANT on the receiver.
l) Two batteries
m) CompactFlash card
n) Radio antenna
o) Radio antenna arm 3 cm long
p) 1.2 m antenna cable to connect radio housing
and radio antenna
q) Telescopic rod
r) Minipack
GPS1200+
74
Advertisement
Table of Contents
