Table of Contents
Advertisement
Manage...\Data
Step
Description
•
For <Thematc Codes: Without Codelist>:
Codes for points can be typed in but not selected from a codelist.
<Code:> The code to be stored with the point. A check is
performed to see if a point code of this name already exists in the
job. If so, the according attributes are shown.
<Attribute n:> Up to eight attribute values are available.
6.
Is <Thematc Codes: With Codelist>?
•
If yes, continue with the next row.
•
If no, continue with step 7.
NEW-A (F2) allows additional attributes to be created for this point
code.
NAME (F3) or VALUE (F3)
Available for attributes for which an attribute name can be typed in.
To highlight <Attribute n:> or the field for the attribute value. The
name of <Attribute n:> can be edited and an attribute value can be
typed in.
LAST (F4) recalls the last used attribute values which were stored
with this point code.
DEFLT (F5) recalls the default attribute values for the selected code.
7.
STORE (F1) stores the new point entered and all associated informa-
tion and returns to MANAGE Data: Job Name, Points page.
The properties stored with the point are:
GPS1200+
Refer to
chapter
172
Advertisement
Table of Contents
