Table of Contents
Advertisement
Equipment setup step-
by-step
Next step
Equipment Setup
f) Receiver
GX1210+/GX1220+/GX1220+ GNSS/
GX1230+/GX1230+ GNSS
Step
Description
1.
Refer to "1.6 Post-Processed Kinematic, All-on-Pole - Option 2". Follow steps 1. to
8.
2.
Attach the radio in its housing to port P1 or P3 the receiver.
3.
Screw the radio antenna onto the housing.
4.
Press PROG on the RX1210 to switch the receiver on.
IF the receiver
has been pre-programmed
requires programming
When using the upper pole half with stub, ensure that the GNSS antenna and the screw-to-
stub adapter slide down the full length of the stub before tightening the locking ring. An incor-
rectly mounted GNSS antenna will have a direct effect on the results.
l) CompactFlash card
AND the RX1200 is
being used
being used
GPS1200+
Refer to chapter
45
14
83
Advertisement
Table of Contents
