Working Example 1 - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Requirements

Configuration of ASCII

Input interface step-by-

Config...\Interfaces... - General

Working Example 1

Application:

Working technique:

The port and the device to be used for the depth sounder is configured correctly. The device

will most likely be RS232 using the same parameters as the depth sounder. Refer to "23.2

Accessing CONFIGURE Devices / CONFIGURE GPRS Internet Devices".

Refer to "22.4.1 Overview" to access CONFIGURE ASCII Input.

Survey on a small lake.

Recording the depth with the survey points.

Using a depth sounder to measure the depth of the lake at certain

The depth sounder constantly streams data at a rate of 1 Hz and

sends the depth it has measured to the GPS1200+ receiver in the

The ASCII Input interface needs to be configured such that when

a position is measured, the depth measurement will be stored as

annotation 1 with that point.