Combining Linework And Coding - Leica GPS1200+ Technical Reference Manual

12.3
Description
Configuration options
Linework

Combining Linework and Coding

Linework and coding can be combined.
This combination can be useful, because coding, assigning linework flags and
opening/closing lines/areas can all be done with one point observation.
Combining Linework and coding can only be configured if thematical point codes or if themat-
ical point, line and area codes are available for selection. Thematical coding can be done
with or without codelists.
Linework and coding can also be combined using SmartCodes. Refer to "11.5.4 Using
SmartCodes".
The configuration for the types of codes available and the configuration for coding
with/without a codelist both have an influence on the following:
• The required configuration of a display mask.
• The behaviour of the fields configured for the display mask.
• The behaviour of the software.
The possible configurations and their influence are shown in this table:
Configuration in CONFIGURE Coding & Linework
<Show Codes:> Only Pt Codes
<Thematc With Codelist
Codes:>
Required fields and their appearance in display mask
Without Codelist With Codelist
GPS1200+
All Codes
Without Codelist
273