Table of Contents
Advertisement
Equipment setup step-
by-step
Next step
Equipment Setup
Step
Description
1.
If a pillar plate is being used, locate the pillar plate on the pillar.
2.
Screw the tribrach to the pillar plate or the pillar.
3.
Level the tribrach.
4.
Place and lock the carrier in the tribrach.
5.
Screw the GNSS antenna onto the carrier.
6.
Check that the tribrach is still level.
7.
Insert the batteries into the receiver.
8.
Insert the CompactFlash card into the receiver.
9.
Connect the receiver to the GNSS antenna using the antenna cable and port ANT
on the receiver.
10.
Attach the RX1210 to the receiver if required.
11.
Press the ON/OFF button on the receiver for at least 2 s or PROG on the RX1210
to switch the receiver on.
12.
Once operating, the receiver can be placed in the transport container for additional
protection.
IF the receiver
has been pre-programmed
has been pre-programmed
requires programming
AND the RX1200 is
not being used
being used
being used
GPS1200+
Refer to chapter
3
45
14
33
Advertisement
Table of Contents
