11.5.4
Measuring points using
Code Blocks step-by-
step
Coding
Using SmartCodes
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to paragraph "Creating a Code Block step-by-step" to access
SURVEY Survey: Job Name, SCode page.
2.
Move the focus on a code box.
When <String Attrib:> is active, you can type in an attribute value
below the code name of the highlighted code box.
+ (F4) or - (F5) to increase or decrease the value. Applies only if the
value is numeric.
3.
OCUPY (F1)
For <Measure Point: Yes> in SURVEY Survey: Job name, SCode
page, tapping the code box with the supplied stylus automatically
starts measuring the point. Selecting the code box by using the arrow
keys will not start measuring the point.
4.
STOP (F1)
5.
STORE (F1)
The point is stored with the code assigned to the highlighted code
box.
GPS1200+
Refer to
chapter
11.5.3
261