Post-Processed Kinematic, All-On-Pole - Option - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver

Hide thumbs Also See for GPS1200+:

Table of Contents

Equipment Setup

Post-Processed Kinematic, All-on-Pole - Option 1

The equipment setup described below is to be used for post-processed kinematic rover

surveys with short periods of use, especially where there are many obstacles such as fences.

The RX1200 is fixed to the pole grip with a holder. With another holder, the receiver is fixed

to the pole. One connection is needed to connect the GNSS antenna to the receiver. Another

connection is needed to connect the RX1200 to the receiver.

GNSS antenna is mounted directly using screw fitting. If using stub and adapter, proce-

dures may vary slightly.

Aluminium poles are used. They may be replaced with their carbon fibre equivalent

without any change to these instructions.