Equipment set-up step-
by-step
Next step
Equipment Setup
d) Holder for receiver together with RX1210 on
pole
e) RX1210
Step
Description
1.
Screw the two halves of the pole together.
2.
Slide the grip onto the pole.
3.
Attach the holder for receiver together with RX1210 and tighten the screw.
4.
Screw the GNSS antenna to the top of the pole.
5.
Screw the receiver, with RX1210 attached, to the holder.
6.
Insert the batteries into the receiver.
7.
Insert the CompactFlash card into the receiver.
8.
Connect the receiver to the GNSS antenna using the 1.2 m antenna cable and port
ANT on the receiver.
9.
Press PROG on the RX1210 to switch the receiver on.
IF the receiver
has been pre-programmed
requires programming
When using the upper pole half with stub, ensure that the GNSS antenna and the screw-to-
stub adapter slide down the full length of the stub before tightening the locking ring. An incor-
rectly mounted GNSS antenna will have a direct effect on the results.
i) Two batteries
j) CompactFlash card
AND the RX1200 is
being used
being used
GPS1200+
Refer to chapter
45
14
51