Error Code "0001 - Xerox DOCUPRINT N17 Service Manual

7.3.17.3 Error Code "0001"

You were directed to this RAP because the Control Panel displayed the error code "0001" during the
Power On Diagnostics.
1 Switch OFF the printer power.
2 Reseat the System Controller and then switch on the printer power.
3 The control panel displays "READY".
Y: Go to Final Actions.
N: Observe the Diagnostic LED at power on.
NOTE: If the LED flashes, refer to Table 7.3.17.1.1 Diagnostic LED Flash Sequence Table If the LED
does not glow or glows continuously, perform RAP 7.3.17.1 Power On Diagnostics (POD)
Failure.
Repair Analysis Procedures (RAPs)
6/98
www.printcopy.info
7-36 Xerox DocuPrint N17 Service Manual