Area Stub - Dell Networking 2024 Reference Manual

Example
The following example defines an area range for the area 20.
console(config-router)#area 20 range 192.168.6.0 255.255.255.0 summarylink
advertise

area stub

Use the area stub command in Router OSPF Configuration mode to create a
stub area for the specified area ID. A stub area is characterized by the fact
that AS External LSAs are not propagated into the area. Removing AS
External LSAs and Summary LSAs can significantly reduce the link state
database of routers within the stub area. Use the no form of the command to
remove the stub area.
Syntax
area-id
area stub
area-id
no area stub
area-id — Identifies the area identifier of the OSPF stub. (Range: IP
•
address or decimal from 0–4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Examples
The following examples define area 3 for the stub and then removes the stub
area.
console(config-router)#area 3 stub
console(config-router)#no area 3 stub
OSPF Commands
1205