Configuring The Ftp Test - H3C S5500-EI series Operation Manual

Operation Manual – NQA
H3C S5500-EI Series Ethernet Switches
Note:
As DHCP test is a process to simulate address allocation in DHCP, the IP address of
the interface performing the DHCP test will not be changed.

1.6.3 Configuring the FTP Test

The FTP test is mainly used to test the connection with a specified FTP server and the
time necessary for the FTP client to transfer a file to or download a file from the FTP
server.
I. Configuration prerequisites
Before the FTP test, you need to perform some configurations on the FTP server. For
example, you need to configure the username and password used to log onto the FTP
server. For the FTP server configuration, refer to File System Management
Configuration.
II. Configuring the FTP test
Follow these steps to configure the FTP test:
Enter system view
Enter NQA test group
view
Configure the test type as
FTP and enter test type
view
Configure the destination
address for a test
operation
Configure the source IP
address of a probe
request
To do... Use the command...
system-view
nqa entry admin-name
operation-tag
type ftp
destination ip
ip-address
source ip ip-address
1-9
Chapter 1 NQA Configuration
Remarks
—
—
Required
Required
By default, no destination
IP address is configured for
a test operation.
The destination IP address
for a test operation is the IP
address of the FTP server.
Required
By default, no source IP
address is specified.
The source IP address
must be that of an interface
on the device and the
interface must be up.
Otherwise, the test will fail.