Gigabit Ethernet Interface Commands / Queries - Comtech EF Data SLM-5650B Installation And Operation Manual

C.6.8

Gigabit Ethernet Interface Commands / Queries

The instruction codes that follow are valid only when the optional 10/100/1000Base-T Gigabit Ethernet Interface Module is installed in the
SLM-5650B Satellite Modem.
Command
Arguments for
Parameter
(Instruction Command or
Code and Response to
Type
Qualifier)
GBEI Flow GFC= 1 byte
Control
GBEI WAN
WBL= 3 bytes
Buffer Length
Appendix C
Description of Arguments
Query
Command or Query.
Used to Enable/Disable Pause Frame flow control on the internal
GBEI Interface, where x is:
0 = Disabled
1 = Enabled
Example: GFC = 0
Command or Query.
Used to set the WAN Buffer (transmit) Length, where xxx is in
range from 020 mSec to 240 mSec
Example: WBL = 020
Response to
Command
GFC=
GFC?
GFC*
GFC#
WBL=
WBL?
WBL*
WBL#
C–62
SLM-5650B Satellite Modem
Revision 2
Query
Response to
(Instruction
Query
Code and
Qualifier)
GFC? GFC=x
(see Description of
Arguments)
WBL? WBL=xxx
(see Description of
Arguments)
MN-SLM-5650B