Backup Programming-Automatic (#123) - Avaya PARTNER Installation And Use Manual

Slot 2 is recommended for the Backup/Restore PC Card; however, you can use either slot. If
the system detects Backup/Restore PC Cards in both slots when a backup to a PC Card
begins, the first slot is used and the second is ignored.
The same Backup/Restore PC Card can be used for both automatic and manual backups to a
PC Card, since the data is recorded in two separate files. An automatic backup replaces the
INTERNAL AUTO.mmddyy file or PC CARD AUTO.mmddyy file only, and a manual backup
replaces the INTERNAL MAN.mmddyy file or PC CARD MAN.mmddyy file only.
Verify that the System Date (#101) and System Time (#103) are set correctly. These settings
are not backed up.
Calls continue to be handled normally during an automatic or manual backup.
The configuration of the 1600 DSL module is not backed up to the PARTNER ACS R7.0
processor or a PCMCIA card. Instead, the configuration is retained in the flash memory of the
1600 DSL module. Upon a system cold-start, the configuration retained in the flash memory
becomes the "active" configuration of the 1600 DSL module.
Backup Programming—Automatic (#123)
Use this feature to set up the automatic backup of all programming (except the system date and
time). When Backup Programming—Automatic is set to Active Internal or Active PC Card, the
information is backed up at 2:00 a.m. on the first day of each month (determined by the system
date and time settings) to either the internal memory of the processor module or a Backup/Restore
PC Card.
If Backup Programming—Automatic is Active Internal or Active PC Card and an automatic
backup fails, a Backup-Failure Alarm message appears (instead of the system date and time) on
the top line of the telephone display at idle Extensions 10 and 11. The message is one of the
following:
Backup Failed:Memory Err
Backup Failed:Check Card
Backup Failed:SystemBusy
Backup Failed:InsertCard
See Chapter 11, "Troubleshooting"
corrective actions, and for the procedure for clearing the Backup-Failure Alarm message.
Programming
To change the setting for Backup Programming—Automatic:
1. If you want to back up to a PC Card, check that only one Backup/Restore PC Card is in the
processor module. If you do not have a PC Card installed, see
10-2 or refer to the PARTNER PC Card Installation Instructions that came with your PC Card.
f00ss#123
2. Press
The current setting appears.
for an explanation of these messages and suggested
Programming System Options
4
4
"Using a PC Card" on page
at extension 10 or 11.
Backup and Restore
4-5