Avaya PARTNER Installation And Use Manual page 202

®
PARTNER Advanced Communications System Installation, Programming, and Use
Using Conference on a System Telephone
Follow these steps to originate a conference call on a system telephone:
1. Set up the call to the first party. (You can call the party, pick up the call from hold, or answer an
incoming call.)
C
2. Press .
The first party is now on hold.
3. Set up the call to the second party.
If you are adding an inside party to a call, you must wait until the party answers. If you are
active on a call using a pool button and you want to set up a conference call by using one of
the other lines in that pool, you can press
access to another line in that pool.
C
4. Press again to add the second party to the call.
You can now speak with the first and second parties.
5. Repeat Steps 2 through 4 to add more parties.
Using Conference on a Single-Line Telephone
Follow these steps to originate a conference call on a single-line telephone:
1. Set up the call to the first party. (You can call the party, pick up the call from hold, or answer an
incoming call.)
2. Press the switchhook down once rapidly.
The first party is now on hold. You hear intercom dial tone.
3. Do one of the following:
To add an outside party, dial
number is busy or does not answer, hang up and the first party rings back.
To add an inside party, dial the two-digit extension number. If the extension is busy or does
not answer, press the switchhook down once rapidly and you are reconnected with the
first party.
4. When the second party answers, press the switchhook down once rapidly.
5. You are now connected with both parties.
Handling Calls
6-26
i
and dial the pool's access code to gain
9
or a pool access code plus the outside number. If the
6
6