Avaya PARTNER Installation And Use Manual page 35

8. Fasten the carrier to the modules by using the
two #4 screws included with the carrier (see
Figure ).
9. Insert the 3-1/2 inch #8 screw into the bottom of
the modules (see
mounting tracks of the PARTNER ACS
processor module are flush against the wall. Do
not overtighten or the module will warp. Then
go to the next procedure,
page 2-9.
Figure ). Tighten it until the
"Labeling Jacks" on
Figure 2-6. Fastening the 2-Slot
Carrier
Figure 2-7. Tightening the Bottom
Screw
Installing the Control Unit
Installation
2-7