Restore Programming (#125) - Avaya PARTNER Installation And Use Manual

e
4. Press .
A status message is displayed indicating that a backup is in progress, and within 30 seconds,
a message appears indicating the result.
If the backup was successful, the new backup information replaces the information in the
MAN.mmddyy file on the processor module or Backup/Restore PC Card, and the mmddyy
extension now reflects the current date. Backup information on one media type (PC Card or
internal flash memory) is not impacted when you save to the other media type.
If the backup failed, you see one of the following error messages (see
"Troubleshooting"
Backup Failed:Check Card
Backup Failed:SystemBusy
5. Exit programming mode.
If you exit the procedure before the backup finishes, you do not interrupt the backup,
but you do not see feedback messages on the display.

Restore Programming (#125)

Use this feature to reinstate your system and telephone programming (except the System Date
and System Time) to the settings saved on the processor module or a PC Card at the last system
backup (manual or automatic). You should restore the system settings if your system settings
become corrupted, if you make changes and decide you would rather use the former settings, or if
you replace your processor module and want to retain the system settings you had on the previous
processor module. A successful restore takes about five seconds.
When a restore completes successfully, the Restore Complete message appears for two
seconds at idle extensions 10 and 11. Then a System Reset—Programming Saved
(#728) occurs, disconnecting any calls in progress. You should warn users before
beginning a restore, or do the restore during nonbusiness hours.
Considerations
Make sure that you have saved the most recent system settings before you begin the Restore
procedure.
If the restore is not successful, the display shows Restore Failed or Restore Failed-
Try Again for two seconds. All calls in progress are disconnected, and all of the system and
telephone programming settings revert to the factory settings.
The configuration of the 1600 DSL module is not saved on the processor module or PC card; it
is retained in the flash memory of the 1600 DSL module. To restore this configuration, you
must perform a cold-start by using Restore Programming or System Reset—Programming
Saved (#728).
for explanations and corrective actions):
Programming System Options
Chapter 11,
4
4
Backup and Restore
4-7