®
PARTNER
Advanced Communications System Installation, Programming, and Use
3. Press the power cord firmly into the power jack on
the carrier or the stand-alone processor module
until the cord locks into place (see
4. Plug the other end of the power cord into a
properly grounded three-prong wall outlet that is
not controlled by a switch.
5. If you have a 5-slot carrier, move the On/Off
switch to the On ("—") position.
CAUTION:
The power cord should hang straight down from
the connector for the entire length of the module
or carrier. Do not install the power cord at an
angle to the case or with a loop in it.
Installing the Control Unit
2-14
Figure 2-16. Attaching the Power
Figure
).
Cord
Stand-Alone
2-Slot
5-Slot