Programming Connections For The 1600 Dsl Module; Initial Configuration Of The 1600 Dsl Module - Avaya PARTNER Installation And Use Manual

Programming Connections for the 1600 DSL Module

The programming of the 1600 DSL module is
separate from the programming of the PARTNER
ACS. You can program the 1600 DSL module either
locally or remotely.
To locally program the module, connect a cable from
a PC's serial port to the Console port on the module.
You can set up the module for remote programming
by following these steps (see
1. Connect a cable from an extension port on the
system to the Line jack on an external modem.
The modem should have the following
parameters:
14.4 kbps or greater
Auto-Answer is enabled
DTR override is enabled
Echo commands are Suppressed
Result and Error codes are Suppressed
2. Connect a cable from the serial port on the
modem to a null modem.
3. Connect a cable from the null modem to the
Console port on the 1600 DSL module.

Initial Configuration of the 1600 DSL Module

Remote administration of the 1600 DSL module is available through the PARTNER ACS R7.0 PC
Administration software. You must have the following:
Release 5.0 or later software on the 1600 DSL module
Release 7.0 software version of PARTNER ACS
PARTNER ACS R7.0 PC Administration software
For more information, see the PARTNER
Figure ):
®
ACS R7.0 PC Administration Getting Started.
2
Figure 2-23. Remote Programming
Setup
PARTNER ACS
Tip/Ring
Extension Port
1600 DSL Module
Console Port
2
The 1600 DSL Module
Installation
External Modem
Null Modem
2-25