Programming Mode; Changing Programming Type - Avaya PARTNER Installation And Use Manual

Programming Mode

When you are ready to program a system or telephone feature, you must enter programming
mode. Follow these steps to enter programming mode.
1. Place the Programming Overlay over the dialpad of the system display telephone at extension
10 or 11.
2. To enter programming mode, press
PROGRAM EXTENSION 10
(If you are programming from extension 11, "11" appears instead of "10.")
s
3. Press
10 Enter Extension Name
This display is for the Extension Name Display feature. When you are entering System
Programming mode, skip it by moving on to Step 4.
s
4. Press
SYSTEM PROGRAM
5. Specify a programming procedure in one of two ways:
Direct Method: Dial the code for that procedure. System Programming procedures in this
guide are identified by a # and a three-digit code (for example, System Date is #101).
This method is best when you are using only a few procedures during a programming
session and you know the codes.
Cycle Method: Cycle through the procedures in numerical order. Press
P
method is best when you are using multiple procedures during a programming session, or
if you do not know the codes.
6. To exit programming mode, you can press
place it back in the cradle.
You can talk on the telephone while you program. This is useful if you call for support
while programming. However, you must call before you enter programming mode,
and you must use the handset to talk, not the speaker and microphone.

Changing Programming Type

When you are in programming mode, you can move between System Programming and
Centralized Telephone Programming. To change to Centralized Telephone Programming when
you are in System Programming, press
when you are in Centralized Telephone Programming, press
f00
. A display similar to the following appears:
again. A display similar to the following appears:
to cycle forward and backward through the programming procedures. This
c
3
. A display similar to the following appears:
f00
. Or you can lift the handset and then
3
. To move back to System Programming
c
Initial System Programming
N
s
, then
Using System Programming
and
.
3-7