Avaya PARTNER Installation And Use Manual page 56

®
PARTNER Advanced Communications System Installation, Programming, and Use
d. Select "2. Modify Existing DLCI" from the FR DLCI Config Menu.
e. Do one of the following:
If you are configuring a voice connection, type the port number for "Proprietary Voice
DLCI," and press Enter.
If you are configuring a data connection or a voice or data connection for a PathStar
gateway, type the port number for "RFC 1490," and press Enter.
f. Select one of the following from the FR Encapsulation Configuration menu:
Select "3. RFC 1490" for a PathStar gateway.
Select "2. Proprietary Voice DLCI" for another gateway.
g. Select "1. Configure Transmit CIR" from the FR DLCI Options menu.
h. Type the "committed burst size" in bits, as provided by the service provider, at the prompt,
and press Enter. A rule of thumb is 100,000 bits x the number of channels used.
i. Type the bits/second of the Circuit Throughput at the prompt, and press Enter. Usually you
enter the factory setting of 272,000.
j. Type "0" at the "excess burst size" prompt, and press Enter.
k. Select "2. Configure Receive CIR" from the FR DLCI Options menu.
l. Repeat Steps h, i, and j above for the Receive CIR.
m. Press Esc to return to the WAN Configuration Menu.
12. Select "4. Configure Maintenance Protocol" from the WAN Configuration Menu.
13. Select the appropriate Frame Relay Maintenance Protocol from the following. Obtain this
information from your service provider.
0. None
1. CCITT Q.933 Annex A Network
2. CCITT Q.933 Annex A User
3. CCITT Q.933 Annex A Both
4. ANSI T1.617 Annex D Network
5. ANSI T1.617 Annex D User
6. ANSI T1.617 Annex D Both
7. LMI Network (FRF.1.1)
8. LMI User (FRF.1.1)
9. LMI Both (FRF.1.1)
14. Press Esc to return to the Main Menu.
The 1600 DSL Module
2-28