Examples - Avaya PARTNER Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Examples

Pause: To call an answering machine at 555-0529, wait 4.5 seconds; then dial
retrieve messages, enter
Recall/Centrex Feature Button: The following entry shows how to program an Auto Dial
button with a Centrex feature you use while on a call, for which the feature access code is
*32. This example includes a Recall signal to send a switchhook flash to the Centrex system
when you are already on a call. (You can store a Recall signal by pressing
the first character stored.) It also includes a 1.5-second pause (which you insert by pressing
h
) to allow time to get a new Centrex dial tone:
Stop: Your local bank-by-phone service requires that you enter a password before the
account number. To program a Personal Speed Dial number or an Auto Dial button to call the
bank at 555-7898, include a stop for manually entering the password, and continue with the
account number (679 88), enter
Touch-Tone Enable: Your system is connected to rotary lines but you want to call an
answering machine at 555-3454 to retrieve messages. Since the machine requires touch
5553454&
tones, enter
touch tones.
On/Off Centrex Feature Button: To include both the activation and deactivation codes for a
Centrex feature on the same button, press
For instance, if the code to activate a Centrex feature is
*31
the feature is
The first time you press the Auto Dial button, only the number before the stop is dialed (to
activate the feature). When you press the button again, the rest of the stored number is dialed
(to deactivate the feature).
Number Outside a PBX or Centrex System: To store a number that dials out of a PBX or
Centrex system, include a dial-out code in the Speed Dial number. This entry, to dial the
number 201 555-4321, includes a dial-out code, a 1.5-second pause, and a toll call prefix of 1
for direct dialing (which may not be required for your dialing area):
4321
.
Examples
B-2
5550529hhh321
5557898!67988
. All digits pressed during the rest of the call are sent as
!
*30!*31
, store
1 1
.
Sh*32
.
.
to include a stop between the two codes.
*30
and the code to deactivate
on the Auto Dial button.
9h1201555
321
to
S
, but only if it is