Backup Programming-Manual (#124) - Avaya PARTNER Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
3. To change the setting, press
r
to return the setting to the factory setting. The possible settings are:
1 = Active Internal
2 = Active PC Card
3 = Not Active (the factory setting) 
4 = Backup Alarm Cleared
4. Exit programming mode.
For information about using Option 3, Backup Alarm Cleared, see
Alarm" on page 11-4.
Backup Programming—Manual (#124)
Use this feature to manually back up all the programming (except the system date and time) to
either the internal memory of the processor module or a Backup/Restore PC Card.
Programming
To begin a manual backup of system settings:
1. If you want to back up to a PC Card, verify that only one Backup/Restore Card is in the
processor module. If you do not have a PC Card installed, see
10-2 or refer to the PARTNER PC Card Installation Instructions that came with your PC Card.
f00ss#124
2. Press
The current setting appears.
3. To change the setting, press
r
to return the setting to the factory setting. The possible settings are:
1 = Internal Memory (the factory setting) 
2 = PC Card
If there is a problem, one of the following messages appears (see
"Troubleshooting"
Memory Error
Insert Valid Card
SystemBusy
If there is no problem, press Enter to begin the backup.
Backup and Restore
4-6
D d
or
D d
or
for explanations and corrective actions):
until the setting you want appears, or press
"Clearing a Backup-Failure
4
4
"Using a PC Card" on page
at extension 10 or 11.
until the setting you want appears, or press
Chapter 11,