Avaya PARTNER Installation And Use Manual page 55

6. From the SDSL Configuration menu, select the speed of the connection as directed by your
service provider. You will most likely do one of the following:
Select one of the following for negotiated speed:
— 3. Set SDSL Speed to Auto Cycle (Nokia)
— 4. Set SDSL Speed to Auto Sense (Copper Mountain)
— 5. Enable Conexant AutoBaud Mode
— 6. Set SDSL Sync Delay (Lucent)
Select "7. Set SDSL Speed Manually" to manually set the speed. At the prompt, enter the
speed in kbps for the connection, and press Enter.
7. Press Esc until you return to the WAN Configuration Menu.
8. Select "1. Configure Datalink Protocol."
9. Select one of the following from the WAN Datalink Protocol Configuration Menu, according to
the equipment of your service provider, and press Esc:
6. ATM
7. Frame Relay
10. If you selected "6. ATM" in Step 9, follow these steps:
a. Select "3. Configure PVCs" from the WAN Configuration Menu.
b. Select "4. Show Current PVCs" from the ATM PVC Config Menu.
c. The PVC port screen appears, showing the present ATM PVC ports and their
configurations. Press any key to return to the ATM PVC Config Menu.
d. Select "2. Modify Existing PVC" from the ATM PVC Config Menu if you need to change the
ATM PVC.
e. At the PVC port screen, type the number of the port you want to configure, and press
Enter. This should be the PVC the service provider has designated for voice.
f. Type the Virtual Port Identifier (VPI) at the prompt, and press Enter.
g. Type the Virtual Circuit Identifier (VCI) at the prompt, and press Enter.
h. At the ATM Encapsulation Configuration menu, select one of the following:
"3. Proprietary Voice" for CopperCom and Jetstream gateways.
"4. RFC 1483" for PathStar gateways.
i. If you selected "4. RFC 1483" in Step h above, select "1. CBR" from the ATM Service
Category Configuration menu. Press Enter at the Select Peak Cell Rate prompt.
j. Press Esc until you return to the WAN Configuration Menu.
11. If you selected "7. Frame Relay" in Step 9, follow these steps:
a. Select "3. Configure DLCIs" from the WAN Configuration Menu.
b. Select "4. Show Current DLCIs" from the FR DLCI Config Menu.
c. The DLCI port screen appears, showing the present DLCI ports and their encapsulation.
Press any key to return to the FR DLCI Config Menu.
Installation
The 1600 DSL Module
2-27