Avaya PARTNER Installation And Use Manual page 49

c. In the Line Type area, perform one of the following steps:
— If the PARTNER system will use this line, click the T1-E&M option button, and then go
to Step d.
— If the PARTNER system will not use this line, click the T1-UNEQ option button. Since
this line will not be used by the PARTNER system, you are finished with this
procedure. Go to Step 8.
d. From the Disconnect Time box, choose the outward disconnect time interval for the line.
e. From the Ring Pattern box, choose the ringing pattern for the line.
f. From the Group Call Distribution box, choose the Hunt Group to which you want to assign
the line. This setting is not used for T1 lines with Direct Inward Dialing.
g. From the Line Coverage Extension box, choose the extension to be assigned ownership
of the line. This setting is not used for T1 lines with Direct Inward Dialing.
h. In the Voice Mail System (VMS) area, choose when outside calls should be answered by
the Automated Attendant Service of the voice messaging system during the day and when
outside calls should be answered by the Automated Attendant Service of the voice
messaging system when the system is in Night Service. This setting is not used for T1
lines with Direct Inward Dialing.
i. In the Voice Mail System (VMS) area, choose whether the outside lines assigned to Hunt
Group 7 hunt through the VMS Hunt Group all the time, only during Day operation (Night
Service is off), or only during Night operation (Night Service is on). This feature affects
only the Automated Attendant Service of the voice messaging system. This setting is not
used for T1 lines with Direct Inward Dialing.
j. If the PARTNER system is operating in Hybrid (pooled) mode, choose the pool to which
this line will be assigned. This setting is available only when the PARTNER system is
operating in Hybrid (Pooled) mode.
k. From the Assign Line for DID Operation box, choose whether Direct Inward Dialing is
administered for this line by your T1 Service Provider.
l. From the Incoming Seizure Type box, choose the type of incoming signaling for this line.
m. From the Outgoing Seizure Type box, choose the type of outgoing signaling for this line.
n. From the Supply Local Dial Tone box, choose whether the PARTNER system should
provide dial tone when PARTNER users go offhook.
o. From the Incoming Answer Supervision Time (msec) box, choose the incoming answer
supervision time for the line.
Repeat Steps b through o for each T1 line you are using.
8. If you will be using the Direct Inward Dialing (DID) feature from the T1 service provider,
configure the DID Mapping Table. To map DID lines to extensions, hunt groups, and calling
groups:
a. In the PARTNER ACS System window, double-click on System.
b. In the PARTNER ACS System window, click on DID Mapping Table.
The DID Mapping Table window appears.
Installation
The T1 Module
2-21