Considerations; Programming - Avaya PARTNER Installation And Use Manual

Considerations

You cannot assign a line that belongs to a pool as an individual line on that pooled extension.
A line must be assigned to a button with lights. If a line is assigned to a button without lights,
you cannot access that line, nor can you program anything else on the button.
You can assign multiple lines (up to 31) to a standard telephone, but a single-line telephone
can handle only one call at a time. To make a call, you lift the handset and dial 9 at the
intercom dial tone; the system selects the first available line based on the Automatic Line
Selection programmed for the extension. (Alternatively, you can use Direct Line Pickup to
access a specific line.)
Use Number of Lines (#104) only during initial system setup to assign a subset of lines to all
extensions. Use Line Assignment to assign additional lines to specific extensions. For
example, if five lines were assigned to all extensions using Number of Lines (#104) and there
are eight lines in the system, use Line Assignment (#301) to assign lines 6, 7, and 8 to
specific extensions.
After you finish Line Assignment, use Line Ringing to identify when each outside line
assigned to an extension should start ringing. If you add a line to the system, its factory setting
is Immediate Ring.
Use Automatic Line Selection to determine the order in which the system selects a line for
an extension when the user at that extension lifts the handset or turns on the speaker to make
a call. If you add a line to the system, it becomes the last line in the selection sequence.

Programming

To assign lines to a specific extension:
f00ss#301
1. Press
2. Enter the extension number to be programmed. For example, to program extension 15, press
15
. The red light next to each button that has a line assigned is on steady; the red light next
to each button that has a pool assigned flashes.
3. To remove all existing line assignments, press
4. Enter the line number to be assigned. For example, to select line 1, press
5. Do one of the following:
If you want to assign the line to the first available button with lights, press
display reads:
Line Assignment 15 L01
1 Assigned
1 Assigned is the factory setting.
If you want to remove a line assignment, press
appears:
Line Assignment 15 L01
2 Not Assigned
4
4
at extension 10 or 11.
r
before selecting a line.

D
Programming System Options
01
.
D
until a display like the following
Line Assignment (#301)
until the
4-47