Avaya PARTNER Installation And Use Manual page 367

2. For all types of installations, disconnect the power cord from the wall outlet.
3. If you do not have a 5-slot carrier, go to Step 4.
If you have a 5-slot carrier:
a. Loosen the thumb screw at the bottom of the carrier cover.
b. Rotate the carrier cover to disengage the tabs at the top of the modules from the openings
on the top of the carrier.
CAUTION:
Remove all other PC Cards from the processor before initiating an upgrade.
4. To insert the PC Card, hold it with the label facing to the right and slide it gently into either PC
Card slot on the processor module (see
projects about 1-5/8 inch (4 cm) from the module.
Figure 10-2. Inserting the PC Card
5. Power up the system:
a. Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the
plastic case. Do not install the power cord at an angle to the case or with a loop in it.
b. If you have a 5-slot carrier, move the carrier's On/Off switch to the "On" position ("—").
Figure 10-2). When inserted properly, the PC Card
PFT
L
I
N
E
S
PFT
L
206
I
MODULE
N
E
PFT
S
E
X
T
E
N
S
I
206
MODULE
O
N
PFT
S
E
X
T
Upgrading the System
Using a PC Card
10-3