Avaya PARTNER Installation And Use Manual page 104

®
PARTNER Advanced Communications System Installation, Programming, and Use
Using Restore
To initiate a restore:
1. f you want to restore from a PC Card, verify that only one Backup/Restore Card is in the
processor module. If you do not have a PC Card installed, see
10-2 or refer to the PARTNER PC Card Installation Instructions that came with your PC Card.
f00ss#125
2. Press
The top line of the display shows Sys Set Restore or System Settings Restore.
3. Choose the backup file you want to use for the restore:
1 Internal MAN.mmddyy, where "mmddyy" represents the date of the manual backup
to the internal memory of the processor module.
2 PC Card MAN.mmddyy, where "mmddyy" represents the date of the manual backup on
the PC Card.
3 Internal AUTO.mmddyy, where "mmddyy" represents the date of the automatic
backup to the internal memory of the processor module.
4 PC Card AUTO.mmddyy, where "mmddyy" represents the date of the automatic
backup on the PC Card.
e
4. Press to start the restore.
If the system detects an error before beginning the restore, the bottom line of the display
shows one of the following messages (See
about these messages):
Insert Card or Insert Valid Card
Bad File or Bad File-Try Again
Incompat Version or Incompatible Versions
Empty File
Backup and Restore
4-8
If the date of the file (AUTO. mmddyy or MAN. mmddyy) indicates that this is
not the file you intended to use, see the instructions packaged with the PC
Upgrade card for how to install the Backup/Restore PC Card.
If the Backup/Restore PC Card is fresh from the factory, and no backups have
been recorded on it yet, the filenames are PC CARD MAN . ****** and PC
CARD AUTO . ******, respectively. You cannot use these files for a restore;
they generate the error message Empty File after you press
If the processor card is fresh from the factory, and no backups have been
recorded on it yet, the filenames are PC CARD MAN . ****** and PC CARD
AUTO . ******, respectively. You cannot use these files for a restore; they
generate the error message Empty File after you press
4
"Using a PC Card" on page
at extension 10 or 11.
Chapter 11, "Troubleshooting"
e
in Step 4.
e
in Step 4.
for more information