Connecting A Partner-Ca48 Intercom Autodialer - Avaya PARTNER Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Connecting a PARTNER-CA48 Intercom Autodialer

You can connect a PARTNER-CA48 Intercom Autodialer to a PARTNER telephone at an
operator's extension. The Intercom Autodialer is shipped with an adapter, a D8W line cord, a
power cord, a power unit, and a button-labeling sheet.
You can wall-mount the Intercom Autodialer to work next to a wall-mounted system
telephone. See the instructions provided with the Autodialer.
Follow these steps to connect an Intercom Autodialer to a PARTNER telephone:
1. Plug the adapter into the wall jack
(see Figure 2-35).
2. Plug one end of the D8W line cord into
the J1 jack on the adapter.
3. Plug the other end of the D8W line cord
into the IN jack on the bottom of the
Autodialer.
4. Plug the blue-tinted connector (labeled
D8AC) of the power cord into the jack
on the power unit.
CAUTION:
Use only the power unit supplied
with the PARTNER-CA48
Intercom Autodialer.
5. Plug the other end (clear tinted) of the
power cord into the J2 jack on the
adapter.
6. Plug the power unit into an electrical
outlet.
7. Plug the telephone's modular
telephone cord (LINE jack) into the
OUT jack on the bottom of the
Autodialer.
Installing Telephones
2-40
2
Figure 2-35. Connection of Cords for the
Intercom Autodialer
Adapter
D8W Cord
Ext.
Intercom Intercom
Feature
+ 1
GHI
– Conf
4
Mic PQRS
Transfr 7
HFAI
Spkr Hold *
D8AC Cord
Message
ABC DEF
2 3
JKL MNO
5 6
TUV WXYZ
8 9
0 #
Modular
Telephone
Cord