Send And Receive Modem - Avaya PARTNER Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
Programming
To program a modem for sending only:
1. Do one of the following:
If extension X is a key extension, use Line Assignment (#301) to assign one or more
lines to extension X.
If extension X is a pooled extension, use Pool Extension Assignment (#314) to assign
the pools you want the modem to use to extension X. Also use Line Assignment (#301)
to assign any individual lines you want the modem to use to extension X.
2. If the modem only dials outside the system, set Automatic Line Selection for extension X to
select outside lines first. If you also use the modem for calls within the system, set Automatic
Line Selection to select intercom first and include a 9 or a pool access code and a couple of
pauses in the modem's dialing sequence for outside calls.
3. Set Line Ringing for all lines and pools assigned to extension X to No Ring.
4. Set Automatic Extension Privacy (#304) for extension X to Assigned.
Make sure extension Y is not assigned as a Call Waiting (#316) extension, Pickup
Group Extension (#501), Calling Group Extension (#502), Night Service Group
Extension (#504), or Hunt Group Extension (#505).
5. Set the auto answer feature of the modem to Off.

Send and Receive Modem

If you need to place and receive calls with the modem, use the setup shown in
setup makes line A the primary modem line but keeps the line available for users at other
extensions when all other lines are busy.
Figure 9-13. Send and Receive Modem
Modems
9-30
Modem
Line A
Ext
Lines
PARTNER
ACS
9
9
X
MODEM
Figure 9-13. This