Avaya PARTNER Installation And Use Manual page 378

®
PARTNER Advanced Communications System Installation, Programming, and Use
6. Check the slack in the wires. If there is not enough slack to remove the module without pulling
the line and extension cords free, label and disconnect the wires.
7. Place one hand on top of the module. With the other hand, grip the plastic bracket on the
bottom front of the module, and pull out the old module (see
Figure 10-11. Removing the Module
8. If you are replacing a module with one of a different type, make sure that all 400 (or 200)
modules are installed to the right of all 012E, 308EC, or 206 modules, and that the processor
module remains in the center slot. If you have a T1 module or a 1600 DSL module, it must be
in the first slot on the left of the carrier.
PARTNER ACS Release 7.0 supports Endeavor telephones when an Endeavor
362EC module is installed in the carrier. Install the Endeavor 362EC module(s) to the
right of the T1 module or 1600 DSL module, if one is installed, and to the left of any
400 and 200 module.
9. To insert the replacement, once the module is properly seated, firmly push the center of the
module until the connectors on the module lock into place, and the module is attached to the
rear of the carrier. For proper engagement of the connectors, the module must be inserted
straight into the carrier (see
Replacing Modules
10-14
PFT
L
I
N
E
S
206
MODULE
PFT
E
X
T
E
N
S
I
O
N
S
Figure 10-12). A slight click indicates the connectors are engaged.
Figure 10-11).