Initializing The System - Avaya PARTNER Installation And Use Manual

5. With the locking latch in the unlocked position
(battery icon and "minus" icon visible), slide the
battery assembly into the processor module
along the battery guides on the inside of the
battery compartment (see
the battery assembly in far enough that the
edges of the assembly slip behind the plastic
housing of the processor module.
6. Pressing lightly on the battery icon on the front of the battery assembly, slide the locking
latch downward to secure the assembly in place. The "plus" icon and the battery icon should
now be visible on the front of the battery assembly (see

Initializing the System

Before you initialize the system, you may insert any of the supported PC Cards: Backup/
Restore card, Automatic System Answer/Direct Extension Dial (ASA/DXD) card, PARTNER
Voice Messaging Small/Large card, and PARTNER Remote Access PC Card.
You must power down the system before you insert or remove a PC Card.
Follow these steps to initialize a system:
1. If you have a 5-slot carrier, make sure the carrier's On/Off switch is at the Off ("O") position.
2. If you have a PC card, perform the following steps:
a. If your PC Card comes with a write-protect tab, verify that the write-protect tab on
the PC Card is not in the write-protected position. If it is, use a paperclip or another
pointed object to push the write-protect tab on the end of the PC Card upward to
the nonprotected position.
b. To insert the PC Card, hold it with the label facing to the right, and slide it gently into
one of the PC Card slots on the processor module. When inserted properly, the PC
Card projects about 1-5/8" (4 cm) from the module.
Figure 2-15). Push
Figure 2-15. Sliding the Battery
Assembly into the
Processor Module
Tab
Figure 2-13).
2
Installing the Control Unit
Installation
Locking Latch
2-13