SULB-1033
Message
AUDIT, <timestamp>, [SULB-1033], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Switch has completed relocating the internal firmware image.
Probable Cause
Indicates that the firmwareDownload process has completed normally on the switch.
Recommended
Run the firmwareShow command to verify the firmware versions. Run the switchShow command to
Action
make sure the switch is enabled.
Severity
WARNING
SULB-1034
Message
AUDIT, <timestamp>, [SULB-1034], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload timed out.
Probable Cause
The error may be caused by a switch initialization issue after the internal image is relocated. It may
also be caused by an internal Ethernet issue or by persistent storage failure.
Recommended
Reboot the switch. This will cause the internal image to be relocated again. Use the
Action
firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch
service provider.
Severity
ERROR
SULB-1035
Message
AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , An error has occurred relocation of the internal image.
Probable Cause
Indicates that an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
Action
contact your switch service provider.
Severity
ERROR
SULB-1037
Message
AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , HCL failed. Reboot the switch manually using the reboot
command. However, it will disrupt the FC traffic.
Probable Cause
Many reasons can cause HCL to fail, such as domain not confirmed.
Recommended
Run the reBoot command to reboot the switch manually.
Action
Fabric OS Message Reference
53-1000437-01
83
SULB-1033
491