Fcr-1024; Fcr-1025; Fcr-1026 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference
Brocade fabric os message reference - supporting fabric os v5.3.0 (53-1000437-01, june 2007)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Administrator's manual (452 pages)
Table of Contents
Advertisement
Recommended
Limit the number of port WWNs required by limiting the remote edge fabric connectivity (which
Action
limits the number of translate domains). You can also limit the number of proxy devices for a
translate domain (which limits the number of translate domain ports required) by limiting the
devices specified in logical storage area network (LSAN) zones.
Severity
WARNING
FCR-1024
Message
<timestamp>, [FCR-1024], <sequence-number>,, WARNING, <system-name>, Local LSAN
zone
Probable Cause
Indicates that the number of devices in a logical storage area network (LSAN) defined in the edge
fabric exceeds the local LSAN zone database limitations.
Recommended
Remove excess device entries from this LSAN zone until the number of devices is within the range
Action
of the local LSAN zone database limitations.
Severity
WARNING
FCR-1025
Message
<timestamp>, [FCR-1025], <sequence-number>,, WARNING, <system-name>, Local
phantom node WWN entries exhausted.
Probable Cause
Indicates that the number of node world-wide names (WWNs) detected to be in use exceeds the
local node WWN resources.
Recommended
Reduce the number of node WWNs required by limiting the remote edge fabric connectivity (which
Action
limits the number of translate domains).
Severity
WARNING
FCR-1026
Message
<timestamp>, [FCR-1026], <sequence-number>,, INFO, <system-name>, In slot <slot
number> Node WWN roll over.
Probable Cause
Indicates that the node world-wide name (WWN) pool has rolled over in the specified slot, and
WWN entries detected to not be in use are reused as needed.
Recommended
It is unlikely that WWN conflicts will occur as a result of pool rollover unless the switch is deployed
Action
in a very large MetaSAN environment with large number of logical storage area network (LSAN)
devices and fabrics, or there are highly dynamic changes to EX_Port connectivity. WWN conflicts
might cause unpredictable behavior in management applications.
To avoid WWN conflicts, all EX_Ports attached to fabrics with highly dynamic changes to EX_Port
connectivity should be disabled then reenabled.
Severity
INFO
Fabric OS Message Reference
53-1000437-01
<zone name>
device entries for edge LSAN exhausted.
20
FCR-1024
123
Advertisement
Table of Contents
