Ips-1001; Ips-1002; Ips-1003; Ips-1004 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

IPS System Messages

IPS-1001

Message
<timestamp>, [IPS-1001], <sequence-number>,, WARNING, <system-name>, <message>
FCIP License Not Installed (<error>)
Probable Cause Indicates that the FCIP license is not installed on the switch.
Recommended Run the licenseShow command to check the installed licenses on the switch. Contact your switch
Action supplier for a FCIP license. Run the licenseAdd command to add the license to your switch.
Severity WARNING

IPS-1002

Message
<timestamp>, [IPS-1002], <sequence-number>,, ERROR, <system-name>, Failed to
initialize <module> rc = <error>
Probable Cause Indicates that an initialization of a module within the IPS daemon failed.
Recommended Download a new firmware version using the firmwareDownload command. Refer to the Fabric OS
Action Command Reference for more information on this command.
Severity ERROR

IPS-1003

Message
<timestamp>, [IPS-1003], <sequence-number>,, WARNING, <system-name>, <function
name>(): Failed to allocate memory while performing <message>
Probable Cause Indicates that memory resources are low. This might be a transient problem.
Recommended If the message persists, check the memory usage on the switch, using the memShow command.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

IPS-1004

Message
<timestamp>, [IPS-1004], <sequence-number>,, WARNING, <system-name>, Port Config
Mode Mismatch slot (<slot>) port(ge<port>): current mode is (<current mode>)
Fabric OS Message Reference
53-1000437-01
Chapter
38
271