Sulb-1033; Sulb-1034; Sulb-1035 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

Probable Cause Indicates that the switch has rebooted with the new firmware and is relocating the AP firmware.
Recommended Wait for the operation to complete.
Action
Severity WARNING

SULB-1033

Message
<timestamp>, [SULB-1033], <sequence-number>, AUDIT, WARNING, <system-name>,
Switch has completed relocating the internal firmware image.
Probable Cause Indicates that the firmwareDownload process has completed normally on the switch.
Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to
Action make sure the switch is enabled.
Severity WARNING

SULB-1034

Message
<timestamp>, [SULB-1034], <sequence-number>, AUDIT, ERROR, <system-name>,
Firmwaredownload timed out.
Probable Cause The error may be caused by a switch initialization issue after the internal image is relocated. It may
also be caused by an internal Ethernet issue or by persistent storage failure.
Recommended Reboot the switch. This will cause the internal image to be relocated again. Use the
Action firmwareDownloadStatus to monitor the progress. If the problem persists, contact your switch
service provider.
Severity ERROR

SULB-1035

Message
<timestamp>, [SULB-1035], <sequence-number>, AUDIT, ERROR, <system-name>, An
error has occurred during relocation of the internal image.
Probable Cause Indicates that an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
Action contact your switch service provider.
Severity ERROR
Fabric OS Message Reference
53-1000600-01
69
SULB-1033
445