Ms-1009; Ms-1021; Ms-1022 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

48

MS-1009

MS-1009
Message
<timestamp>, [MS-1009], <sequence-number>,, ERROR, <system-name>, RLIR event.
Switch Port ID is <PID>. Device Port Tag is <port tag>. <message>.
Probable Cause A Registered Link Incident Record (RLIR) has been generated for one of the actions clarified by the
<message> passed in.
The following messages might be displayed:
•
•
•
•
•
Recommended Persistent RLIR incidents are likely due to SAN hardware problems such as bad cables, small
Action form-factor pluggables (SFPs), etc. It may be necessary to replace hardware if these messages
persist.
Severity ERROR

MS-1021

Message
<timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>, MS WARMBOOT
failure(FSS_MS_WARMINIT failed. Reason=
Probable Cause Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during WARM INIT
phase of a reboot.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR

MS-1022

Message
<timestamp>, [MS-1022], <sequence-number>,, INFO, <system-name>, Management
Server Platform Service
Probable Cause Indicates that Management Server Platform Service is being activated or deactivated.
Recommended No action is required.
Action
Severity INFO
296
Exceeded bit error rate threshold
Loss of signal or synchronization
Not operational seq. recognized
Primitive sequence timeout
Unrecognized link incident
<Activated or Deactivated>
<failure reason>
)
Fabric OS Message Reference
53-1000437-01