Sec-1301; Sec-1302; Sec-1303 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SEC-1301

Message
<timestamp>, [SEC-1301], <sequence-number>,, INFO, <system-name>, This switch is
in interop mode. Security is not supported.
Probable Cause Indicates that the switch is interop-mode enabled.
Recommended Disable interop-mode using the interopMode command before enabling the Secure Fabric OS
Action feature.
Severity INFO

SEC-1302

Message
<timestamp>, [SEC-1302], <sequence-number>,, INFO, <system-name>, This switch
does not have all the required PKI objects correctly installed.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity INFO

SEC-1303

Message
<timestamp>, [SEC-1303], <sequence-number>,, INFO, <system-name>, This software
version does not support security.
Probable Cause Indicates that the currently installed software version does not support the Brocade Secure Fabric
OS feature.
Recommended Run the firmwareDownload command to update the firmware to the latest version for your specific
Action switch. Verify that the firmware you are installing supports the Brocade Secure Fabric OS feature.
Severity INFO
Fabric OS Message Reference
53-1000437-01
63
SEC-1301
385