Sysc-1001; Sysc-1002; Sysc System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SYSC System Messages

SYSC-1001

Message
<timestamp>, [SYSC-1001], <sequence-number>, FFDC, CRITICAL, <system-name>,
Failed to run <Name of program that could not be run (string)>:<System internal
error message (string)>.
Probable Cause Indicates that during the boot sequence, one of the programs would not run on the system.
Recommended If the message is reported during a reboot after new firmware has been loaded, try reloading the
Action firmware using the firmwareDownload command.
If the message persists, there might be a conflict between the two versions of firmware or the
nonvolatile storage might be corrupted. Run supportFtp (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity CRITICAL

SYSC-1002

Message
<timestamp>, [SYSC-1002], <sequence-number>, FFDC, CRITICAL, <system-name>,
Switch bring-up timed out.
Probable Cause Indicates that the system timed out during a reboot or failover sequence, waiting for one or more
programs to register with system services or to fail over to active status.
Recommended The switch is in an inconsistent state and can be corrected only by a reboot or power cycle. Before
Action rebooting the chassis, record the firmware version on the switch or control processor (CP) and run
the haDump command. If this is a dual-CP switch, then gather the output from the CP in which this
log message appeared.
Severity CRITICAL
Fabric OS Message Reference
53-1000437-01
Chapter
68
417