Fw-1050; Fw-1051; Fw-1052 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

FW-1050

Message
<timestamp>, [FW-1050], <sequence-number>,, WARNING, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has fallen below the low
boundary.
Recommended Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0
Action (Out_of_Range). If continuous or repeated alarms occur, replace the SFP before it deteriorates.
Severity WARNING

FW-1051

Message
<timestamp>, [FW-1051], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has risen above the high
boundary. High voltages indicate possible hardware failures. Frequent voltage fluctuations are an
indication that the SFP is deteriorating.
Recommended If you see frequent voltage fluctuations, replace the SFP.
Action
Severity WARNING

FW-1052

Message
<timestamp>, [FW-1052], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed from a value
outside of the acceptable range to a value within the acceptable range.
Recommended No action is required. Respond to this message as is appropriate to the particular policy of the
Action end-user installation.
Severity INFO
Fabric OS Message Reference
53-1000437-01
27
FW-1050
165