Snmp-1001; Snmp-1002; Snmp-1003; Snmp System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SNMP System Messages

SNMP-1001

Message
<timestamp>, [SNMP-1001], <sequence-number>,, ERROR, <system-name>, SNMP service
is not available
Probable Cause Indicates that the simple network management protocol (SNMP) service could not be started
because of the specified Reason. You will not be able to query the switch through SNMP.
Recommended Verify that the IP address for the Ethernet and Fibre Channel interface is set correctly. If the
Action specified Reason is an initialization failure, the switch requires a reboot.
Severity ERROR

SNMP-1002

Message
<timestamp>, [SNMP-1002], <sequence-number>,, ERROR, <system-name>, SNMP
Details>
Probable Cause Indicates that the initialization of the simple network management protocol (SNMP) service failed
and you will not be able to query the switch through SNMP.
Recommended Reboot or power cycle the switch. This will automatically initialize SNMP.
Action
Severity ERROR

SNMP-1003

Message
<timestamp>, [SNMP-1003], <sequence-number>,, ERROR, <system-name>, Distribution
of Community Strings to Secure Fabric failed.
Probable Cause Indicates that the changes in the simple network management protocol (SNMP) community strings
could not be propagated to other switches in the secure fabric.
Recommended Retry changing the SNMP community strings from the primary switch.
Action
Severity ERROR
Fabric OS Message Reference
53-1000437-01
<Reason>
.
initialization failed.
Chapter
64
<Error
395