Zone-1028; Zone-1029; Zone-1030 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

ZONE-1028

Message
<timestamp>, [ZONE-1028], <sequence-number>,, WARNING, <system-name>, Commit zone
DB larger than supported - <zone db size> greater than <max zone db size>.
Probable Cause Indicates that the zone database size is greater than the limit allowed by the fabric. The limit of the
zone database size depends on the lowest level switch in the fabric. Older switches have less
memory and force a smaller zone database for the entire fabric.
Recommended Edit the zone database to keep it within the allowable limit for the specific switches in your fabric.
Action Refer to the Fabric OS Administrator's Guide for information on the zone database sizes supported
for each switch.
Severity WARNING

ZONE-1029

Message
<timestamp>, [ZONE-1029], <sequence-number>,, WARNING, <system-name>, Restoring
zone cfg from flash failed - bad config saved to <config file name> [<return
code>].
Probable Cause Indicates that the zone configuration restored from the flash was faulty.
Recommended This error will save the faulty zone configuration in the zoned core file directory.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

ZONE-1030

Message
<timestamp>, [ZONE-1030], <sequence-number>,, WARNING, <system-name>, Converting
the zone db for PID format change failed.
Probable Cause Indicates that the current zone database could not be converted to reflect the PID format change.
Most likely this is caused by the size of the zone database.
Recommended Change the PID format back to its original format. Reduce the size of the zone database. Then you
Action can change the PID format to the requested format.
Severity WARNING
Fabric OS Message Reference
53-1000437-01
77
ZONE-1028
451